-
The applied
surface should be free from any dust , oil , grease , enamel /
paint
coat and should be properly cleaned with emery paper , wire brush
etc before
using Steel Guard. Only one single coat is to be applied and under
no
circumstances should it be recoated.
-
Always pour / unload Steel Guard chemical only in a PVC /
Plastic container
and not in any other metallic container.
-
After applying Steel Guard on the desired metallic surface, it
should be
allowed to cure for 24 hrs. for the entire chemical process to
complete and should be strictly kept away from water during the
curing duration. However, the curing time can be reduced by using
air blowers.
-
Steel Guard Nanocoat
TM is a ready to use product and NO additives
are to be used.
-
Always wear Hand Gloves , Eye Goggles while using Steel Guard .
-
In case any part of the body does come in contact with the
solution, kindly wash it with soapy water first and than plain
water for safety purposes.
-
In case Steel Guard is spilled or leaked during transportation
& storage, simply wipe it off with a cloth and wash it with plain
water.
-
These white red spots, if observed is the internal rust which
is coming out in the form of dead salt once the chemical starts
reacting with the metal and can be cleaned off easily using a wet
cloth or any fine emery paper with light hands.
-
Once kept to cure for 24 hrs. the applied surface is
completely rust free and these visual appearances do not have any
effect on the quality of coating i.e. its bonding & rust resisting
abilities of Steel Guard Nanocoat
TM.
-
It can be painted further with any Synthetic Enamel, Epoxy,
Polycoat which will bond with the applied surface more strongly
because of the greater adhesions properties of Steel Guard.
-
The application of Red Oxide primer is not necessary after
applying Steel Guard Nanocoat
TM.
